Lighting Control Systems : Related Lighting Control Products : Crestron Electronics, Inc. - GL-EXP-DIMFLV-DALI

0 to 10V Green Light Fluorescent Dimmer Expansion Module with DALI Communication

Series: GL-EXP

Model: GL-EXP-DIMFLV-DALI

Part #: 6507039

Provides one channel of 0-10 Volt dimming control for 120 Volt or 277 Volt loads up to 16 Amps
Provides switching for non-dimmable loads
Communicates with the DALI® protocol
Has a built-in air gap relay
Mounts to a wall or above a suspended ceiling

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Related Products

Documents

The Crestron Green Light® GL-EXP Series delivers a family of professional lighting control modules for Cresnet® or DALI® based lighting systems. Designed for easy installation on a wall or above a suspended ceiling, these modules offer a perfect solution for adding extra lighting zones to any system without requiring an additional lighting cabinet.

The GL-EXP-DIMFLV-DALI is a single-channel dimmer expansion module designed to dim 0-10 Volt ballasts and drivers and can be used to switch non-dimmable loads.

This module communicates using the DALI (Digital Addressable Lighting Interface) protocol, an open standard that focuses on providing uniform, comfortable, and reliable lighting between devices from different manufacturers.

The GL-EXP-DIMFLV-DALI is designed to be mounted to a vertical surface and complies with UL 2043 standards for installation in an environmental air-handling space above a suspended ceiling. Conduit knockouts are provided on the bottom and lower sides of the unit. All connections are made via screw terminals behind the front cover.

Provides one channel of 0-10 Volt dimming control for 120 Volt or 277 Volt loads up to 16 Amps
Provides switching for non-dimmable loads
Communicates with the DALI® protocol
Has a built-in air gap relay
Mounts to a wall or above a suspended ceiling
UL 2043 compliant for installation in plenum-rated ceilings

Warranty - Yes
Spec Sheet available - Yes

Operating Temperature (Maximum): 104 F
Operating Temperature (Minimum): 32 F
Current Draw: 16 Amps
Color: Grey
Certifications: FCC, CE
Warranty (Length/Type): 3 Years Limited
AC Voltage: 277 Volts
Depth: 3.19 in
Height: 8.75 in
Width: 6.36 in
Shipping Weight: 3.43 lbs
Load Ratings:
- Dimmer Channels: 1
- Load Rating: 16 Amps
- Dim Load Types: 0-10 Volt fluorescent ballast or LED driver (4-wire)
- Switch Load Types: LED, incandescent, fluorescent, magnetic low-voltage, electronic low-voltage, neon/cold cathode, high-intensity discharge (HID), motors
Input Voltage: 120/277 Volts AC, 50/60 Hz
COMMUNICATIONS: DALI®
Connections:
- NEUT: (3) Captive screw terminals, ^[2] neutral connection for feed and load
- LINE: (2) Captive screw terminals, ^[2] line power input and loop-through
- SW: (1) Captive screw terminal, ^[2] switched load output
- 0-10V:
  - (2) Captive screw terminals, ^[2] dimming control output;
  - Class 1 or Class 2 wiring allowed;
  - Control voltage is 0-10 Volts DC, 70 mA
- DALI: (2) 2-pin 5mm terminal blocks; Controls a single DALI loop (up to 32 ballasts); 3kVAC isolation between Cresnet/Ethernet ports; Wire Gauge: 28 AWG to 12 AWG
Controls & Indicators:
- PWR: (1) Green LED, indicates line power is applied to the HOT terminal
- NET: (1) Yellow LED, indicates network communication
- ERR: (1) Red LED, indicates presence of an error message
- ON/OFF: (1) Red LED and (1) pushbutton, LED indicates power is applied to the load and pushbutton toggles power to the load on and off
- RESET: (1) Pushbutton, initiates factory reset
Environmental: Humidity: 10% to 90% RH (non-condensing)
Enclosure: Surface mount^[1] module with (2) integral mounting flanges, galvanized steel with gray matte powder coat front panel, extruded aluminum heat sink, and (4) 1/2” or 3/4” conduit knockouts provided on bottom and lower left & right sides
Notes:
- 1. Must be oriented upright, mounted to a vertical surface, with 6 in (153 mm) minimum spacing above and below it for proper ventilation and heat dissipation.
- 2. Captive screw terminals accept up to two 22 to 12 AWG (0.34 to 4.0 mm²) wires per terminal.

GL-EXP-DIM-DALI - Green Light Dimmer Expansion Module with DALI Communication

GL-EXP-DIMFLV-CN - 1-channel Green Light Dimmer Independent Expansion Module

GL-EXP-DIMU-DALI - 1-channel Green Light Universal Dimmer Expansion Module with DALI Communications

GL-EXP-SW-DALI - 1-channel Green Light Switching Expansion Module with DALI Communication

Dimmer Expansion Module 185 kb - Data Sheet

Project List

Dimmer Expansion Module 632 kb - Other

Project List